当前位置: 首页   >   科学研究   >   论文   >   洁净制造   >   正文

A modified normal contact stiffness model considering effect of surface topography洁净制造-2015-张松

作者:    信息来源:    发布时间: 2017-12-28 点击量:

A modified normal contact stiffness model considering effect of surface topography

Zhao, BinZhang, SongMan, JiaZhang, QingChen, Yan

Journal:PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART J-JOURNAL OF ENGINEERING TRIBOLOGY

Abstract:

The contact stiffness of joint surfaces is an important factor influencing the static and dynamic characteristics of the mechanical equipment. In the present research, a modified normal contact stiffness model of two rough surfaces is proposed. First, the stiffness model of a single asperity contact pair is obtained based on shoulder-shoulder contact in conjunction with the elastic-plastic contact model proposed by Jackson and Green. Second, the topographies of contact surfaces are analyzed, and the locations of asperities and the statistical distributions of asperity heights and radii are acquired experimentally. The asperities are then generated using Monte Carlo method with the information to simulate the real contact. Finally, the asperities contact state is determined and if the contact occurs, the stiffness of the single asperity pair is calculated and summed as the total normal stiffness of two contact surfaces. The proposed stiffness model is validated by experiments with the errors less than 10%.

Keywords:

Joint surface; normal stiffness; shoulder-shoulder contact; elastic-plastic contact; surface topography

Download:

A modified normal contact stiffness model considering effect of surface topography

 

教育部直属高校 国家“985”工程 “211”工程 “双一流”重点建设本科大学

 Copyright© 2015 All Rights Reserved. 高校网站模板版权所有  京ICP备15000288 号